New products

Service

Support Form Contact form Documents Driver FAQ Declarations of conformity
ServiceFAQ

FAQ

Bluetooth
Bluetooth Compatibility Connect Bluetooth at the Computer (Windows) Connect Bluetooth at the Handy, Tablet, etc. (Android) Connect Bluetooth by Windows CE/Apple and the mobile phone Driver and Bluetooth
Cable and Accessories
Battery Connector MD6 and RS232 assignment (pin out)
Firmware
Firmware version 3.01 u-blox M8 Standard Precision-GNSS GALILEO
GNSS Receiver
Airplan Mode für uBlox Reciever BT-413 AGPS NL-302U, PN 61422, Windows Compatible
Interface and Driver
COM Port Show Advanced COM Port Access Rights COM Port Configure or Change COM Port doesn't Exist or Appear How can I Check the Installation? Jumping Mouse New Location Sensor Driver for Windows 7/8/8.1 Online Latest Driver
News
Receivers with PPS require PULL UP (Pull-Hi) 10K
Software
Flight Planner 5.6 von ifos GmbH Google Earth Pro GPS-Information (Test and Check) MTK MiniGPS (Test und Check) NL-121X oder 122X Sportuhren NL-456DL und NL-457DL mit TimeMachineX SIRFDemo (GPS protocols)
uCenter
Compatibility Mode for ublox uBlox and Change the Baudrate uBlox-Center A-GPS ublox-Center Compatibility Mode since ublox 6 uBlox-Center Egnos uBlox-Center GLONASS or GPS for ublox 7 uBlox-Center Messages uBlox-Center Update Rate uCenter Manual
Windows-Linux-Apple-Android
Apple Linux Windows 7 Starter Windows CE/Mobile

Receivers with PPS require PULL UP (Pull-Hi) 10K

Please note:
This circuit exists inside of the receiver with a logic level of 0,7V at the GPS_1PPS input to output PPS_OUT. Use a "Pull Up" 10K Ohm resistor with the desired logic level (V_System) for the ajustment (red circle).



Example:
V_System=5V
PPS (Puls Per Second)
Periode 1Hz, Signal 100ms